We install spray foam insulation in Halton Hills, from Georgetown to Acton and the rural hamlets in between. We're about 19 km from the middle of Halton Hills. We go through your house one spot at a time: measure what is there, put the options side by side, and tell you which one we would pick.

Georgetown and Acton homes

Halton Hills has two main centres, Georgetown and Acton, with hamlets and rural roads spread out between them. In Georgetown, Trafalgar Country went up in the mid-1990s and early 2000s, mostly bungalows and two-storey homes. Georgetown South began in 1989 on farmland south of Silver Creek. These are the kind of houses we already work on: newer framed homes, not drafty old ones.

So foam is not our answer for everything here. It suits some spots and is wrong for others. Take an open rim joist in an unfinished basement, which can be done three ways. Closed-cell spray foam seals and insulates in one pass and fills in around an uneven sill plate. It costs more, and the joist bays have to be cleared before we start. Cut foam board also works, but every piece has to be caulked at the edges or air gets past it. Fibreglass batts are the cheapest, and air keeps moving behind them. On a rim joist we would use closed-cell.

Some newer houses already have good depth in the attic and a dry, finished basement. A house like that may not need foam anywhere, and if that is yours, we will tell you so. The decision stays with you.

Garages and basements

Foam is most worth it in the ceiling under a bedroom or bonus room over the garage. Garage insulation for that ceiling comes down to two methods. Closed-cell spray foam goes into the joist bays from below. It slows heat loss and also keeps garage air from rising into the room. Blown or batt fibreglass is cheaper as a material, but it does not seal air. With either one, taking the ceiling drywall down and putting it back up is a big part of the price. Under a bedroom, we would go with closed-cell.

That drywall is also part of the fire separation between the garage and the house. Any gap in it is a fire-separation matter for a qualified contractor or the City, and our crew doesn't do that part.

In the basement, it depends on whether the walls are about to be finished. Before framing, basement insulation can be rigid foam board fixed to the concrete with studs in front, or closed-cell foam sprayed right onto the wall. Foam board is tidier and costs less. Spray foam follows an uneven wall, so damp air has no pockets where it can reach cold concrete. Batts on their own against a basement wall can hold moisture and start to smell musty, so we would not put them there without foam behind them.

Attic floors, pot lights and plumbing stacks

Seal the air leaks before adding anything to the attic. Pot lights in the top-floor ceiling, a plumbing stack coming up through the attic floor, an attic hatch with no weatherstripping: warm air gets out at every one of them. We seal those first with foam or caulk. Then we check the depth across the attic floor with a tape measure and the depth markers.

If the depth is already good, we say so and add nothing. If it comes up short, you can have blown fibreglass over the existing layer or batts laid across the joists. Blown fibreglass fills in around wiring and framing better, so that is our pick. Either way we put baffles in at the eaves, which keeps the soffit vents open and the roof deck getting air.

How far we come

Halton Hills is about 19 km from us. Georgetown, Glen Williams and Norval are the closer part of the drive, and Acton is further north-west. We also go out to the hamlets, Limehouse, Terra Cotta and Hornby among them, and the rural roads in between.

One crew does the inspection, the measuring, the install and the cleanup. The written quote lists the options for each spot in the house. Spray foam is only some of what ends up on that list, and the rest of our work is on the home page. We are open 24 hours, every day, at (437) 563-1419.

About Halton Hills: Halton Hills, ON on Wikipedia ยท Halton Hills on Google Maps

FAQ

Insulation questions from Halton Hills

Yes. We install closed-cell spray foam all over Georgetown, Trafalgar Country and Georgetown South included. We would use it on rim joists and on garage ceilings with living space above. On an attic floor, or in a house that is already well insulated, we will tell you if foam is the wrong choice.

Yes, Acton is in our service area, along with Georgetown and the Halton Hills hamlets. You get the same inspection, measuring and written quote as anywhere else we work. We compare the options for each spot in the house before anything goes in.

Yes. For a garage ceiling under a bedroom we would choose closed-cell spray foam, because one layer insulates and also blocks garage air. Fibreglass is cheaper but lets air from the garage come up through it. The ceiling drywall is part of the fire separation, so any work on it needs approval from the City's building department or a qualified contractor.

Get a quote

Request an insulation visit in Halton Hills

Call (437) 563-1419 or send the form, and tell us what you notice in the house: a cold floor over the garage, a draft at the baseboard, a damp smell in the basement. We measure the spots that matter and give you a written quote with the options side by side.

Call Text Quote