We install spray foam insulation in Clarkson, along with attic top-ups and basement insulation, and Clarkson is about 10 km from us. This page covers L5J, which includes Clarkson and Southdown. Before we put any options in front of you, we measure what your house already has.

Park Royal and the lakeshore

Clarkson is the southwest corner of the city, on the shore of Lake Ontario, with Oakville to the west, Erindale and Erin Mills to the north and Lorne Park to the east. Park Royal was the second subdivision built in Clarkson. It covered 900 acres west of Southdown Road, south of the QEW, and opened on August 8, 1958.

For insulation, the date is what counts. In a house from Park Royal's early years, the attic insulation may have settled over the decades, and the basement may have been finished, redone or left bare. A later house may need far less, and if yours is one of those, we will tell you. Either way we start the same way, with a tape measure on the attic floor and a flashlight along the rim joists.

An older house, more options

In a house from Park Royal's years, we would measure two spots first. Old attic insulation may have settled below the depth markers, and the rim joists in the basement may be bare. You can do either spot alone or both together, and each one changes a different part of the house.

  • Attic only: we air seal around pot lights, plumbing stacks and the attic hatch, then blow fibreglass over the existing layer as an attic top-up. Nothing below the ceiling gets opened up. You may notice it upstairs, with fewer cold patches on the bedroom ceilings on a windy night.
  • Rim joists only: closed-cell foam sprayed onto the rim joists, the framing that sits on the sill plate. Our crew needs to reach every joist bay, so if the basement ceiling along the outside wall is finished, part of it may have to come open. What may change is the draft at the basement baseboard and the cold floor above it.
  • Both: the attic and the rim joists in one job. When both spots measure thin, this is what we would pick, since air moves in and out of a house mostly at the top and the bottom. The written quote prices each part on its own line, so you can do one now and leave the other for later. That call is yours.

When old insulation has to go

If the insulation is wet, damaged by rodents or crumbling, it comes out before anything new goes in. Fresh fibreglass blown over the top just buries the problem. Insulation removal clears the attic floor so we can see the ceiling joists, the drywall and any staining underneath.

Animals living in the attic are a job for a pest-control company, which deals with them and with how they got in before we start. We don't do that part. Mould on the roof boards or joists goes to a mould remediation specialist, and if a roof leak soaked the old insulation, a roofer fixes the leak first. Once the right trade is done, we measure the empty attic again and put its options side by side.

Foam in the basement

An unfinished basement wall is the easiest place to choose how to insulate, because the concrete is bare and nothing has to come down. You have three ways to go. Closed-cell spray foam insulation goes on against the concrete before the framing goes up; it takes the least room and stops air right at the wall. Foam board glued to the concrete with a stud wall in front also works, but every seam needs tape. Batts between the studs are the plainest choice, and they rely on a carefully lapped vapour barrier. If your basement smells damp or the wall feels cold to the hand, we would use closed-cell foam on that wall, and we will still show you the other two beside it.

Next door, we do the same basement and rim joist work in Sheridan. North of Clarkson, our crew handles garage ceilings and attic floors in Erin Mills. Further east along the lake, Port Credit gets the same foam and basement work.

Local details for Clarkson

About Clarkson: Clarkson, ON on Wikipedia ยท Clarkson on Google Maps

FAQ

Insulation questions from Clarkson

Park Royal opened on August 8, 1958, and was the second subdivision built in Clarkson. It covered 900 acres west of Southdown Road, south of the QEW. In a house from those years, we would measure the attic floor and the rim joists first.

An older Clarkson attic usually comes down to two options: air sealing and a blown fibreglass top-up over what is already there, or taking the old material out and laying a fresh layer. A top-up suits an attic where the old insulation has settled but is still dry and intact. If it is wet, crumbling or damaged by rodents, removal comes first. We measure the depth across the attic floor and put both options in the written quote.

Yes, we remove old insulation from Clarkson attics when it is wet, damaged by rodents or crumbling. Before we start, a pest-control company deals with any animals and how they got in, and a mould remediation specialist handles mould on the wood. Then our crew clears the attic floor and puts down new insulation.

Get a quote

Request an insulation visit in Clarkson

Call (437) 563-1419 or send the form, and tell us what you notice in the house: a cold floor over the garage, a draft at the baseboard, a damp smell in the basement. We measure the spots that matter and give you a written quote with the options side by side.

Call Text Quote